Devanco Canada

CPT-223-PER-FT

For DIY quick fixes to repair or replace sensing edges for sectional and rolling steel doors measuring 1-1/2" to 2" thick with a mounting channel.
Sensivity: 15lbs max activation
Lead wire 18"-22 gauge unversal
Wire configuration: N.O.
Electrical interface: sealed module- provides seamless connection to logic or relay type operators
ANSI/UL325 recognized component

MEL-II-TX10

Miller Edge Monitored Edge Link II TRANSMITTER ONLY
Monitors the presence and function of any 10K (T2) monitored sensing edge
Provides a monitored wireless signal transmission from the sensor to the operator controls
Improved immunity to RF interference with 916 MHz operating frequency
Eliminates visible coil cords and retracting reels
Saves installation time

ME123-2M-BLK-U

Worksheet Installation manual Sell sheet

ME113-C7

MEFF-PAIR

Funny Flaps for use with the MC22 Sensing Edge and are a great fit for an application where extra sensitivity is needed
They're necessary to fill the gap between the edge and guide within the sensing edge system and their flexible durable construction offers an alternative to more rigid standard sensing edge setups.

MC22-2WIRE-LH-G

��Electromechanical sensing edge for use on Cornell doors. •The MC22 is manufactured to exact specifications. •The MC22 is completely flexible and will contour to curved surfaces. •Touch sensitive signaling allows immediate reversing or stopping of motion. •Temperature range: -30F to 155F •Lead wire: 22 gauge universal •Sensitivity: nominal 6-8 PSI •2 wire NO configuration •Vertical or horizontal mount •One year warranty

Worksheet

MIRF-T2

Attaches directly to a Sectional door.
The photo eyes travel below the door during the closing cycle.
Unlike traditional static mount photo eyes; Patriot travels with the door sensing obstructions prior to contact.
The Patriot2 non-contact system consists of thru beam photo optics.
Emitting and receiving eyes mount into a rigid steel spring loaded retracting housing.
The housings attach to the bottom section of the door and extend below the leading edge of the door providing an invisible infrared light beam of protection.

MGR20-Y-2R-04

��Electromechanical edge for standard 2" round or square frame sliding sing and bi-part gates. •3-sided activation allows for immediate stopping or reversing of motion •Contours to round or square posts. •Temperature range: -30F to 155F •Lead wire: 18 gauge 2ft length •Sensitivity: nominal 6-8 PSI •2 wrie NO configuration •ANSI/UL325 recognized component •Cannot be bent •One year warranty

MG020-B-4E-P/FT

Electromechanical slide in edge with a small profile for motorized gates and doors rolling shutters and pinch point protection applications.
Touch sensitive signaling
Temperature range: -30F to 155F
Lead wire: 18 gauge 2ft length
Sensitivity: nominal 4 PSI
2 wire NO configuration

MGR20-B-2U-PER-FT

��Electromechanical edge for standard 2" round or square frame sliding sing and bi-part gates. •3-sided activation allows for immediate stopping or reversing of motion •Contours to round or square posts. •Temperature range: -30F to 155F •Lead wire: 18 gauge 2ft length •Sensitivity: nominal 6-8 PSI •2 wrie NO configuration •ANSI/UL325 recognized component •Cannot be bent •One year warranty
Non-monitored edge
Maximum length is 10ft (over 8ft requires LTL shipment at additional cost)